Posts Tagged ‘cable’
June 22nd, 2011 | 
Author: As your CCNA / CCNP home lab expands, an access server such as the Cisco 2509 or 2511 is one of the best investments you can make. In this article, we’ll look at the basic configuration for an access server and discuss how to connect to the other routers and switches in your pod through the AS.
Here’s part of a configuration from one of my access servers:
ip host FRS 2006 100.1.1.1
ip host SW2 2005 100.1.1.1
ip host SW1 2004 100.1.1.1
ip host R2 2002 100.1.1.1
ip host R1 2001 100.1.1.1
ip host R3 2003 100.1.1.1
interface Loopback0
ip address 100.1.1.1 255.255.255.255
no ip directed-broadcast
This is an IP Host table, and this is what makes the entire AS setup work. Your PC will connect to the access server, and the access server is in turn physically connected to your other routers and switches via an octal cable. One end of the octal cable splices off into eight separate cables, each terminated with an Rj-45 connector. That connector will be placed into the console port of one of your home lab devices. In this configuration, I have connector 1 connected to the console port of R1, connector 2 to R2, connector 3 to R3, connector 4 to Sw1, and so forth. (The connectors are physically numbered as well.)
The IP Host table entries here are linked to the loopback address shown. The loopback can be any address, but it must match the address in the IP Host table. This allows you to create reverse telnet sessions to the routers and switches.
To open the reverse telnet sessions upon opening a connection to the AS, type the entire name of the device and press the enter key twice. A connection to that device will now be visible, as shown here:
Read the rest of this entry »
Posted in 
A CCNA or CCNP candidate who wants to be totally prepared for their exams is going to put together a home lab to practice on. With used Cisco routers and switches more affordable and plentiful then ever before, there’s really no excuse to not have one!
With the many different models available, there is some understandable confusion among future CCNAs and CCNPs about which routers to buy and which ones to avoid. You can take almost any set of Cisco routers and put together a home lab; part of the learning process is taking what equipment you have available and putting together your own lab! For those of you preparing to start your home lab or add to your existing one, this article will list the routers I use in my Cisco pods. You certainly don’t have to have all this equipment, but this will give you some good ideas on how to get started.
The most versatile router you can get for your CCNA / CCNP home lab is a 2520. These routers come with four serial ports, one ethernet port, and one BRI interface for ISDN practice. This mix of interfaces means you can actually use it as a frame relay switch while using the ethernet and BRI ports for routing. (There is no problem with using a lab router as both your frame relay switch and a practice router; for a frame relay switch sample configuration, visit my website!)
My pods consist of five routers and two switches, and three of the five routers are 2520s, due to their versatility. A recent ebay search showed these routers selling for $99 – $125, an outstanding value for the practice you’re going to get.
Read the rest of this entry »
